Cytron UC00A Manuale Utente Scaricare il pdf (Pagina 17)

ROBOT . HEAD to TOE

Product User’s Manual –

BlueBee

To set or inquire control parameter, user need to set up hardware interface refer to Section

6 “Hardware Interface”. User may use either SKXBEE-BOARD or UC00A/B and

hypertrminal application to set/inquire the control parameter.

BlueBee module need to set to AT mode shown as figure below. Status LED will blink with

slow blinking when BlueBee in AT mode.

Open and set up HyperTerminal. Bare in mind that the baud rate for AT mode is 38400 bps.

Figure below is an example to send AT command using HyperTerminal.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Nessun commento

Cytron UC00A Manuale Utente Pagina 17